Filter
Top Products
THE MINELAB EXPLORER II
22
www.minelab.com
Connecting the shaft assembly to the handle
assembly
Figure 2.6–2.9
NOTE Shaft orientation: camlock is on lower side of upper
shaft.
To connect the shaft assembly to the handle assembly:
STEP 1 (Figure 2.6) Release the control box camlock lever to the
open position.
STEP 2 (Figure 2.6) Align the connections and push the coil cable
connector into the socket underneath the handle assembly
control box. Ensure the connector’s threaded bracelet is
firmly secured.
STEP 3 (Figure 2.7) To prevent the coil cable from ‘bunching’,
extend the lower shaft from the upper shaft by approximately
15cm (6 inches).
STEP 4 (Figure 2.8) Making sure that the control box camlock lever
is in the released position, push the upper shaft firmly into
the control box until you feel it has reached the back of the
control box.
CONNECTING THE SHAFT ASSEMBLY
CONNECTING THE SHAFT ASSEMBLY
Figure 2.6 Attaching coil cable to
control box
Figure 2.7 Preventing the coil cable
‘bunching’
P0597-A
P0614-A