Filter
Top Products
[4] DISASSEMBLY/ASSEMBLY
[4]-2. Engine and Shaft (cont.)
Repair
P 4/ 22
Assemble by reversing the disassembly procedure.
(1) Put Cable bracket between Flat washer 6 and middle Nut, and tighten them by turning lower nut, upper nut and
the middle nut. (Fig. 7)
(2) Put Stopper on Inner cable end into Swivel, then adjust the above nuts so that 3mm to 4mm of play is left inside of
Swivel under condition that Throttle lever is not pulled. (Fig. 7)
Note: Adjust the tension of Inner cable to prevent the stopper from being removed . (Fig. 7)
(1) Loosen two M6x30 Hex. socket head bolt (2pcs.) and remove Protector with Protector extension attached. (Fig. 8)
(2) Enlarge the space between the side wall of Protector cover and M5x14 Hex socket head bolt, and remove Protector cover
from Shaft pipe complete. (Fig. 9)
(3) Remove two M5x14 Hex socket head bolts then remove Protector clamp.
(4) Loosen M6x30 Hex socket head bolt then remove Gear case assembly. (Fig. 10)
Fig. 7
Play: 3mm to 4mm
Cable bracket of Insulator
complete
Stopper on Inner cable end
ASSEMBLING
DISASSEMBLING
Nut (lower)
Nut (upper)
Nut (middle)
Flat washer 6
Swivel
[4]-3. Shaft pipe complete
Fig. 8
M6x30 Hex. socket
head bolt (2 pcs.)
Protector
Protector clamp
Gear case
assembly
Shaft pipe
complete
M5x14 Hex socket head bolt (2 pcs.)
M6x30 Hex
socket head bolt
Protector extension
Gear case assembly
M5x14 Hex socket
head bolt (2 pcs.)
Fig. 9
Fig. 10
The side wall of
Protector cover