Filter
Top Products
26
General Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Cutting disc Inspect regularly for damage and wear. 6
Clutch Have inspected at a service center.
Protection hood Clean 19
Before each start Cutting disc Inspect for damage and make sure the cutting wheel is 6
right for the job
V-belt Check V-belt tension 13
(note: tension gauge must be purchased separately)
Combination switch, Functional check
Safety locking button, Functional check
Throttle lever Functional check 15
Fuel tank cap Check for tightness
Every day Air filter Clean 19
Idle speed Check (cutting disc must not turn on idle) 17
Every week Fan housing Clean to ensure proper air cooling 11
Starter cable Check for damage 21
V-belt Check V-belt tension, inspect for damage and wear 18
Paper cartridge Clean 20
Spark plug Check and replace if necessary 20-21
Muffler Check tightness of mounting, clean spark arrester screen 11, 24
Every 3 months Suction head Replace 21
Fuel tank Clean
Storage Entire Power Cut Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Cutting disc Remove and clean 12
Fuel tank Empty and clean
Carburetor Run empty
Page
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents! Users of the Power Cut must not perform any maintenance work not
described in this Instruction Manual. All such work must be carried out by a MAKITA service centre.
Service, spare parts and guarantee
Maintenance and repair
The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a MAKITA service centre for all work not described in this instruction manual.
The MAKITA service centres have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective
solutions and advise you in all matters.
Please contact your nearest service centre (list enclosed) or the general trading company or importer (see last page), who will gladly
provide you with the address of your nearest MAKITA service centre.
Spare parts
Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts used.
Use only original MAKITA parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materials,
dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions, functioning and safety.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA product
guarantee.
We will furthermore not accept any liability damages arising from the use of non-MAKITA spare parts.