Filter
Top Products
11
Section 1: Assembly & Set-up
1/07/09
SC2660 & SC2672 Skid Steer Rotary Cutter 326-025M
Land Pride
Table of Contents
Hitch Hook-Up
Refer to Figure 1-5:
!
CAUTION
Do not stand between Skid Steer loader and implement during
hookup.
1. Make sure hydraulic hoses and height adjustment
safety chain do not interfere with hitch hook-up.
2. Drive Skid Steer slowly to the Rotary Cutter making
sure the front hitch plate of the Skid Steer is parallel
with the Rotary Cutter hitch.
3. Tilt top of Skid Steer hitch plate slightly forward.
4. Place top of Skid Steer hitch plate under the Rotary
Cutter top angle bar.
5. Slowly lift Skid Steer’s hitch until Rotary Cutter’s hitch
and Skid Steer’s top angle bar have come together.
6. Push lock handles of the Skid Steer down so that the
pins go through the bottom slots of the Rotary Cutter’s
hitch and the handles lock down.
7. Loop height adjustment safety chain forward down and
under 2" x 3" tube and then attach to Skid Steer’s lower
hitch loop. See “Height Adjustment Safety Chain” on
page 15.
Hydraulic Hose Hook-up
Refer to Figure 1-5:
Two high pressure hydraulic outlets are required for the
hydraulic motor hoses and one outlet for the case drain
hose.
!
DANGER
Hydraulic fluid under pressure can penetrate skin. Wear
protective gloves and safety glasses or goggles when working
with hydraulic systems. Use a piece of cardboard or wood
rather than hands when searching for hydraulic leaks. If
hydraulic fluid is injected into the skin, it must be treated by a
doctor within a few hours or gangrene may result.
1. Remove plastic cap from case drain hose and attach
hydraulic coupler (supplied by customer) to the hose.
2. Connect case drain hose to reservoir outlet.
3. Connect male and female couplers on the hydraulic
motor hoses to the Skid Steer high pressure outlets.
4. Operate skid steer to check blade rotation. Cutter
blades should rotate clockwise when looking at the
blades from above. If cutter blades are rotating
counterclockwise, switch male and female couplers
and reconnect to skid steer outlets.
Skid Steer Hook--Up
Figure 1-5
24538
Top Angle Bar
Bottom Slots
Height Adjustment Safety Chain
(Attach to Skid Steer’s lower hitch loop.)
Rear Skid Shoe
Male Coupler
Female Coupler
Case Drain Line
Clockwise
Blade Rotation