Filter
Top Products
10
Section 1: Assembly & Set-up
RCF2760 and RCF2772 Rotary Cutters 326-460M
12/15/15
Table of Contents
Driveline Installation
Figure 1-4
Refer to Figure 1-4:
1. Remove rubber sleeve (#3) from gearbox input shaft.
2. Remove coupling bolts (#1) from end of
driveline (#5).
3. Unsnap access doors (#4) on both sides of gearbox
shield and rotate doors open.
4. Slide slip-clutch end of driveline (#5) onto gearbox
input shaft until holes in slip-clutch align with notch in
gearbox shaft.
5. Insert coupling bolts (#1) through driveline yoke and
gearbox input shaft.
6. Secure with removed hex nuts (#2). Tighten hex nuts
to the correct torque.
7. Close access doors (#4) on gearbox shield.
8. Raise driveline (#5) up and rotate driveline hook (#6)
down.
9. Lower driveline (#5) until resting in driveline
hook (#6).
10. Continue with “Tractor Hook-Up” on page 11.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to “Lubrication
Points” on page 26.
The tractor’s PTO shaft and cutter gearbox shaft
must be aligned and level with each other when
hooking-up the driveline to the tractor.
An additional driveline may be required if cutter is to
be used on more than one tractor, especially if a
Quick Hitch is used.
30953
Gearbox Vented Dipstick
Refer to Figure 1-3:
A vented dipstick is shipped loose and packaged with the
Operator’s Manual. Remove temporary solid plug from
top of gearbox and replace with vented dipstick. See your
nearest Land Pride dealer if dipstick is missing.
Figure 1-3
Driveline Installation
!
DANGER
All guards and shields must be installed and in good working
condition at all times during cutter operation.
!
DANGER
Do not engage tractor PTO while hooking-up and unhooking
driveline or while someone is standing near the driveline. A
person’s body and/or clothing can become entangled in the
driveline resulting in serious injury or death.
!
WARNING
Always disengage PTO, put tractor in park or set park brake,
shut tractor engine off, remove ignition key, and wait for
blades to come to a complete stop before dismounting tractor.
!
WARNING
Do not over-speed PTO or machine breakage may result.
Some tractors are equipped with multispeed PTO ranges. Be
certain your tractor’s PTO does not exceed 540 RPM.
!
WARNING
Do not use a PTO adapter. A PTO adapter will increase strain
on the tractor’s PTO shaft resulting in possible damage to
shaft and driveline. It will also defeat the purpose of the
tractor’s master shield and could cause bodily injury or death.
IMPORTANT: Rotary Cutters are shipped with a
solid plug in the gearbox to prevent loss of oil during
shipping and handling. The solid plug on top of the
gearbox must be replaced with a vented dipstick. Do
not operate cutter without vented dipstick installed.
30216
DO NOT
OVERFILL!
Oil Level
Plug
Remove
Solid Plug
Install
Vented Dip-