Land Pride RC5015 Brush Cutter User Manual


 
22
Section 3: Adjustments
RC5015 & RC6015 (540 RPM) and RCM5015 & RCM6015 (1000 RPM) Rotary Cutters 318-047M 8/28/08
Land Pride
Table of Contents
Section 3: Adjustments
Center and Wing Section Leveling
These adjustments should be made with the cutter
hooked up to the same tractor that will be used for field
operations or one having the same drawbar height.
Cutter adjusting rods are set at the factory prior to
shipment. The adjusting rods control the draw bar height
at the hitch clevis.
Refer to Figure 3-1, Figure 3-2 & Figure 3-3:
1. Attach the cutter to the tractor and position it on level
ground.
2. Raise both wings to locked position.
Refer to Figure 3-1:
3. Using tractor’s hydraulics, adjust height of center
deck to 2-3 inch clearance between front skids (#2)
and ground. Check deck levelness by making
measurements from center of hinge rod (#1) to
ground at the front and back on both side of the deck.
All measurements should be equal if deck is level.
Front Skid Position
Figure 3-1
Refer to Figure 3-2:
4. If deck is not level, loosen jam nut (#2) on the left side
and rotate leveling rod adjusting nut (#3) until the
deck’s left side is level from front to rear. Re-tighten
jam nut (#2).
Center Section Leveling Rod
Figure 3-2
Front Skid
23574
NOTE: Lengthening leveling rods with adjusting
nuts (#3) will lower the front of the cutter.
15284
Jam
2
3
5. Repeat steps 3 and 4 for the right hand leveling rod.
Be sure that both sides of the deck are equal
distance from the ground and that the right and left
leveling rods are equally tight.
6. See Figure 3-3. Lower wings to ground position.
Wing sections may need adjusting now that the
center section is level. Loosen jam nut (#4) and
rotate the adjusting turnbuckle (#5) to desired
position. Re-tighten jam nut (#4).
Wing Leveling Turnbuckle
Figure 3-3
Cutting Height Adjustment
Refer to Figure 3-4:
The cutter comes standard with hydraulic height control.
Stroke control spacers are supplied to accommodate
various cutting heights.
Hydraulic Cylinder With Stroke Control Spacers
Figure 3-4
15285
Jam
5
4
1
StrokeControl
Spacers
20792