Filter
Top Products
17
Section 1: Assembly and Set-up
8/28/08
RC5015 & RC6015 (540 RPM) and RCM5015 & RCM6015 (1000 RPM) Rotary Cutters 318-047M
Land Pride
Table of Contents
Unhooking From the Cutter
1. Park cutter on a level solid hard surface. Place tractor
gear selector in park and set park brake.
2. Refer to “Transporting The Cutter”, Figure 2-1 &
Figure 2-2 on page 19. Raise wings up in the
transport position and place transport lock bars in
the locked position. Make sure transport bars are
secured in place with lock pins (#2) and hair pins
(#1).
3. Remove stroke control spacers from the center
hydraulic cylinder and lower cutter until front skids
are resting on the ground. Replace stroke control
spacers as needed to support wheels at this
position.
4. With tractor gear selector in park and park brake set,
shut tractor engine off, and remove switch key. Move
cylinder lift levers back and forth to release hydraulic
line pressure.
5. Refer to “Hitch Types” (Figure 1-2) on page 12.
Remove the parking jack (#3) from the left hand wing
deck and install to cutter hitch. Secure the parking
jack in place with attached jack pin (#4).
6. Adjust the parking jack as needed to remove the
hitch pin.
7. Remove hitch pin and unhook hydraulic hoses from
tractor. Store hose ends in hose support loop.
8. Lower the parking jack to rest cutter on its front skids.