Filter
Top Products
32
Section 3: Adjustments
PS25120 Primary Seeder 313-156M
8/21/06
Land Pride
Table of Contents
Small Grass Seeds Attachment
(Optional)
Seed Rate Speed Change
On the left hand side of your seeder is the small grass
seeds drive system. This system is designed to give you
two speeds for different types of seeds and rates. The
two drive types are high range (fast speed) and low
range (slow speed).
To change the drive type on your small seeds drive,
loosen the two set screws on the speed change sprocket,
turn sprocket over and reassemble. Then remove the
bolt on the small seeds drive sprocket, turn sprocket over
and reassemble. If you will be using the low range, you
will need to add links supplied with the kit as shown in
Figure 3-5. Install chains. Adjust idlers to snug up chains.
NOTE: The 38 tooth sprocket on the three sprocket
assembly is used only for the Agitator Option.
Calibrating & Adjusting Seeding Rate
Locate the seed rate adjustment handle at the rear of the
small seeds box, and move it to the indicator number
obtained from the seed rate charts, see page 33. For
best results, first move seed rate adjustment handle all
the way to the left. Then move the handle to the desired
setting, moving from a lower to a higher number.
For further instructions follow directions 2 through 6,
“Calibrating & Adjusting Seeding Rate” on page 20.
12995
12996
Small Grass Seeds Seed Rate Adjustment
Figure 3-5
Low Range
High Range