Filter
Top Products
10
Section 1: Assembly and Set-up
PS25120 Primary Seeder 313-156M
8/21/06
Land Pride
Table of Contents
6. Remove wheel arm pivot shaft from wheel bracket.
7. Position the wheel arm (#10) so that the wheel points
away from the seeder with cylinder bracket up.
Replace wheel arm pivot shaft.
8. Pin the cylinder lock (#11) in storage position.
9. Repeat steps 5-9 for the right hand side.
Refer to Figure 1-7:
10. Install 3 1/4” x 8” x 1 1/4” hydraulic cylinder (#1) and
3 1/2” x 8” x 1 1/4” hydraulic cylinder (#2) and
complete the plumbing as shown in Figure 1-7.
Route the hydraulic hoses (#3) through the spring
hose loop and along the tongue, behind the upper
hitch and through the holes in the box supports,
finishing with the hoses going around the frame end
plates and through the hose retainers on the top of
the wheel brackets. Route the hydraulic hose (#4)
through the holes in the box supports, and finish with
the hose going around the frame end plates and
through the hose retainers on the top of the wheel
brackets. Any excess hose should be coiled and tied
with a plastic tie, placing the coil between the upper
hitch. Position hose clamp (#5) & (#6) as shown and
fasten together with 5/16" long carriage bolt (#7) and
5/16" flange nut (#8). Secure hoses to tongue using
one of the plastic cable ties provided.
NOTE: Your End Wheel Seeder is equipped with
rephasing hydraulic lift cylinders. The plumbing
must be assembled correctly in order for the
rephasing cylinders to function properly.
11. Check to see all nuts are tightened. See Torque
Values Chart in “Section 9: Appendix” on page 48
for torque specifications.
End Wheel Hydraulic Schematic
Figure 1-7
15258
Wheel Bracket & Wheel Arm Assembly
Figure 1-6
12738