Filter
Top Products
29
Section 5: Maintenance and Lubrication
11/14/08
AFM4522 All Flex Grooming Mower 315-360M
Land Pride
Table of Contents
10449
Step 2
Compress Belleville Springs to the
pressure plate by tightening the four
hex nuts and then placing the
assembly into the clutch housing.
Step 3
Bend retaining lugs inward over the
Belleville Spring edges to secure the
spring before backing the four hex
nuts off.
Step 4
With lugs bent in, loosen the four hex
nuts completely to the end of the
threaded studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring,
compression spring, lock collar, and
top backup ring.
Step 7
Install snap ring.
Step 1
Place hub and friction discs into the
housing.
Assembly
Storage
It is good practice to clean off any dirt and grease that
may have accumulated on the mower and moving parts
before storing the mower for a long period and at the end
of a working season.
1. Clean off any dirt and grease that may have
accumulated on the mower and moving parts.
Scrape off compacted dirt from the bottom of the deck
and then wash surface thoroughlywith a garden hose.
A coating of oil may also be applied to the lower deck
area to minimize oxidation.
2. Check blades for wear and replace or sharpen if
necessary. Refer to “Blade Sharpening” on page 27.
3. Inspect mower for loose, damaged or worn parts and
adjust or replace as needed.
4. Lubricate as noted in "Lubrication" starting on
page 30.
5. Release spring tension from drive belt. Refer to
“Blade Removal And Installation” on page 26.
6. Repaint parts where paint is worn or scratched to
prevent rust. Ask your dealer for Aerosol Land Pride
touch-up paint. They are also available in touch-up
bottles with brush, quarts and gallon sizes by adding
TU, QT or GL to the end of the Aerosol part number.
7. Store mower in a clean, dry place.
Tires With Air Pressure
Tire Sealant: Heavy Duty tire sealant has been added in
Air tires to help reduce air loss from punchers due to
nails/thorns etc....
Land Pride Aerosol Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE AEROSOL SPRAY CAN
821-002C PAINT LP BLACK AEROSOL SPRAY CAN
821-054C PAINT MEDIUM RED AEROSOL SPRAY CAN
821-058C PAINT GREEN AEROSOL SPRAY CAN
821-066C PAINT ORANGE AEROSOL SPRAY CAN
821-067C PAINT BLUE AEROSOL SPRAY CAN
NOTE: Under inflated tires can roll off of rim.
Maintaining air pressure within 5 PSI of maximum
tire pressure reduces the risk of tires rolling off of
rim.