Filter
Top Products
14
Section 1: Assembly and Setup
AFM4522 All Flex Grooming Mower 315-360M
11/14/08
Land Pride
Table of Contents
Pull Rope Hook-up
Refer to Figure 1-7:
The operator on the tractor seat will need to be able to
access the pull rope from the tractor seat when lowering
the folded decks to ground level.
Pull Ropes
Figure 1-7
1. Attach pull rope (#1) to an area within the operator’s
reach. Make sure the pull rope can not become
tangled with the operator and driveline.
2. Unfold mower decks as follows:
a. If attached, remove deck lock bar and store in
field position. See “Figure 2-3” on page 19.
13660
Spring Loaded
Transport Locks
1
Toolbar to Wing Deck Hook-up
Figure 1-8
15578
b. Retract hydraulic cylinders to remove weight from
transport locks.
c. Pull transport lock rope (#1) toward the tractor to
disengage locks.
d. Hold locks in this position until all 3 mower decks
have unfolded enough to allow lock lugs to
become fully disengaged.
e. Extend all 3 cylinders to their maximum stroke.
Wing Deck Hook-up
Refer to Figure 1-8:
1. Back transport frame between the two wing decks
until the wing tool bars (#10) are centered over the
wing deck pivot tubes (#11).
2. Unfold both wing tool bars (#10) to a position level
with the ground.
3. Remove 1 1/4” diameter pins (#12) from outer
mounting lugs on both wing tool bars.
4. Roll the left wing deck to align its pivot tube (#11) with
the tool bar’s outer mounting lugs. Hydraulically raise
or lower the tool bar to finishing aligning the holes.
Insert pin (#12) through the mounting lugs and pivot
tube as shown. Secure with bolt (#13) and nut (#14).
5. Repeat step 9 for the right wing deck.