Filter
Top Products
13
Section 1: Assembly and Setup
11/14/08
AFM4522 All Flex Grooming Mower 315-360M
Land Pride
Table of Contents
Tractor Hook-up
!
DANGER
Crushing Hazard between tractor and implement. Do not
allow anyone to stand between tractor and implement while
backing-up to the implement. Never operate hydraulic 3-point
lift controls while someone is directly behind the tractor.
Refer to Figure 1-5:
1. Make certain jack stand is properly attached to the
mower hitch and secured with attachment pin.
2. Back tractor within close proximity of clevis.
3. Raise or lower jack stand to align clevis with tractor
drawbar. Drawbar should fit between lower and
upper plates of clevis.
4. Back tractor up to mower hitch until holes in drawbar
and clevis are aligned.
5. Attach mower with 1" hitch pin and secure it with lock
pin. Always use a pin that contains a safety locking
device to prevent it from falling out.
6. Retract jack stand until weight of mower is fully
removed from the jack. Remove jack and store on
storage tube located on divider gearbox shield.
7. Attach safety chain on the frame tongue to the
tractor. Adjust chain length to remove all slack except
what is necessary to permit turning corners. Lock
chain hook securely on the chain.
8. See “Main Driveline Installation” on page 15 to
connect main driveline to tractor PTO shaft.
IMPORTANT: Jack attachment pin must be fully
inserted and secured before working on or around a
cutter that is not hooked to the tractor drawbar.
Hydraulic Hook-up
Refer to Figure 1-6:
This mower is equipped and plumbed from the factory
with double acting cylinders, hydraulic hoses and
couplings for folding the wings and center deck.
1. Cut plastic ties securing hydraulic hoses (#1) to hose
support loop (#2).
Hydraulic Hook-up
Figure 1-6
2. Route hoses (#1) through hose support loop (#2)
and connect to tractor remote outlets. Quick
disconnect hydraulic fittings for your tractor are
supplied attached to the hoses.
3. Locate carbon steel wire (#3) attached between wing
cylinders (#4). This wire secures the wing tool bars in
the folded position during shipment. Remove wire
and dispose of it in a trash container.
26622
Mower to Tractor Hook-up
Figure 1-5
14918
Jack Retaining Pin
Safety Chain
1” Hitch Pin