Filter
Top Products
15
Section 1: Assembly and Setup
11/14/08
AFM4522 All Flex Grooming Mower 315-360M
Land Pride
Table of Contents
Center Deck Hook-up
Refer to Figure 1-9:
1. Remove 2 center deck front mounting pins (#2) from
transport frame pivot tubes (#8).
2. Loosen the 16 mounting bolts (#6) that secure the
gauge wheel mounting frames to the center deck.
3. Roll center deck forward to align front mounting
tubes (#7) with transport frame pivot tubes (#8).
4. Move storage screw jack from transport frame to jack
stob (#1) centered on the gearbox channel. Make
sure jack retaining pin has been fully inserted to
prevent jack from slipping off of the jack stob. Extend
jack to level the center deck.
5. Install 2 center front mounting pins (#2) to attach
center deck to transport frame.
6. Install C-spacers (#3 & #4) to mounting pin s (#2) as
shown. Use grooves at the bottom of the rods to
install the lower spacers. See also Figure 3-3 on
page 23 for a detailed description.
7. Secure c-spacers at the top with linch pins (#5).
8. Tighten all hardware using torque requirements on
page 39.
Main Driveline Installation
!
WARNING
Damaged drivelines can cause serious injury or death.
!
CAUTION
Tractor PTO shield and all Grooming Mower guards must be
in place at all times during operation!
!
CAUTION
Always engage parking brake, shut off tractor and remove key
before dismounting from tractor.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to “Lubrication”
on page 30.
IMPORTANT: Some tractors are equipped with
multispeed PTO ranges. Be certain your tractor ‘s
PTO is set for 540 rpm.
Center Deck Hook-up
Figure 1-9
15577