Filter
Top Products
36
Section 5: Maintenance & Lubrication
Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor
®
357-187M
1/12/09
Land Pride
Table of Contents
Clean dirt from around fuel tank cap, remove cap and
begin filling. Do not fill fuel tanks to the top if mowing on
hilly terrain or in hot weather. Gas can rise up to the fuel
cap vent hole and seep out. When finished, screw cap
back on securely and wipe up any spilled gasoline. Use
regular unleaded gasoline with an octane rating of 87 or
higher.
Using a fuel stabilizer/conditioner in the fuel can provide
benefits such as:
1. Keeps gasoline fresh during storage of 90 days or
less. For longer storage, drain the fuel tanks.
2. Cleans the engine during operation.
3. Eliminates gum-like varnish build-up in the fuel system.
Add the correct amount of gas stabilizer/conditioner to
the gas. Follow the gas stabilizer/conditioner
manufacturer’s directions for best results.
Fuel Filter
Refer to Figure 5-8:
!
DANGER
Close fuel shut-off valve before replacing fuel filter.
Otherwise, fuel can leak out creating a fire and/or explosion
hazard.
The fuel filter is installed in the fuel line between the
Left/Right Fuel Tank Valve and engine fuel pump.
Location of fuel filter will vary depending on which engine
your mower is equipped with. See engine owner’s
manuals for exact location of fuel filter and instructions
on removal and installation.
Replace filter annually or after every 100 hours of
operation, whichever occurs first. Be sure to install the
fuel filter with Flow Arrow pointing towards the engine
side of the fuel line. Always check fuel line hoses for any
cracks or leaks. Replace as needed.
Fuel Filter
Figure 5-8
IMPORTANT: Never use methanol, gasoline
containing more than 10% ethanol because the fuel
system could be damaged. Do not mix oil with
gasoline.
IMPORTANT: Do not use fuel additives containing
methanol or ethanol.
23803
Flow Arrow Indicates
direction fuel must flow
through the filter.
Draining The Fuel Tank
1. Park the unit on a flat surface. Make sure blade
engagement switch is in the down (OFF) position.
Place control levers in park. Stop engine and remove
ignition key.
2. Disconnect negative battery cable.
3. Trace the fuel line from the tank to the tee under the
Left/Right Fuel Tank Valve (Refer to Figure 5-9.
Remove fuel line hose clamp at the tee and remove
the fuel line from the tee.
4. Place the end of the fuel line into a gas can or a drain
pan to drain the fuel tank.
5. When the fuel tank is drained, re-route the fuel line to
the Left/Right Fuel Tank Valve and reattach with
previously removed clamp.
Fuel Shut-Off Valve (Honda Engine Location Shown)
Figure 5-9
General Engine Maintenance
Detailed instructions and recommendations for break-in
and regular maintenance are specified in the engine
operator’s manual. Please refer to this manual for engine
servicing, lubricating oil levels with quality and viscosity
recommendations, bolt torques, etc. The engine
warranty is backed by the engine manufacturer. Special
attention should be paid to applicable data which is not
duplicated here.
Engine Air Filter
Perform engine air filter maintenance per the engine
operator’s manual.
Engine Oil and Oil Filter
See “Engine Specifications” on page 43 for oil type and
engine capacity.
Check engine oil daily and after every 4 hours of
operation. Crankcase dipstick and engine oil fill tube are
located at the rear of the machine. Mower must be sitting
level when checking oil. Refer to engine manual and
maintenance schedule for oil recommendation and
capacities.
Change the engine oil and filter after the first 5 hours of
operation and per the engine manufacturer’s
recommendations after that. It is recommended oil be
changed more frequently if the mower is being operated
in extremely dirty conditions.
23688
Left/Right Fuel Tank Valve
Center Position “O” as Shown is OFF