Filter
Top Products
15
Section 2: Operating Procedures
1/12/09
Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor
®
357-187M
Land Pride
Table of Contents
Moving Mower with Stalled Engine
Refer to Figure 2-8:
Each hydro-drive is equipped with a bypass valve for the
purpose of moving the mower when the engine is
inoperable.
Moving the mower with a good battery
1. Pull out on the bypass valve rods and lift them into
the slot to lock in position. Both bypass valve rods
are located at the rear of the engine platform.
2. Position both control levers in neutral with the handles
together.
3. Turn ignition switch to on. Do not start the mower.
4. Manually move mower by hand or with a winch.
Moving the mower with a bad battery
1. Pull out on the bypass valve rods and lift them into
the slot to lock them in position.
Refer to Figure 5-6 on page 34:
2. Remove hair pin cotter (#5), flat washer (#3) and
clevis pin (#1) from actuator arm (#2). Be certain to
do this to both the right and left transaxles. Push
brake lever arms up to release park brakes.
3. The mower should move with moderate pressure
once the park brakes have released.
4. Manually move mower by hand or with a winch.
Bypass Valve
Figure 2-8
IMPORTANT: Do not tow machine. Move it by hand
or use a winch and load it on a trailer.
IMPORTANT: Following repairs, always make
certain the two bypass valves are returned to their
operating position and actuator pins are reinstalled.
24895
Bypass Valve Rods
Figure 2-7
Front of Mower Faces This Direction
23923