Filter
Top Products
19
Section 3: Adjustments
1/12/09
Z44 & Z52 (S/N 526171 & Above) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor
®
357-187M
Land Pride
Table of Contents
!
WARNING
Unless specifically required, DO NOT have engine running
when servicing or making adjustments to the mower. Place
both control levers in the park position and remove ignition
switch key. Read and observe safety warnings in front of
manual.
Repairs or maintenance requiring engine power should be
performed by trained personnel only. To prevent carbon
monoxide poisoning, be sure proper ventilation is available
when engine must be operated in an enclosed area.
Your Razor was adjusted before it left the factory and
was checked during pre-delivery set-up. However, after
start-up and continued use, a certain amount of break-in
wear will cause some adjustments to change.
Remain alert for unusual noises, they could be signaling
a problem. Visually inspect the machine for any
abnormal wear or damage. A good time to detect
potential problems is while performing scheduled
maintenance service. Correcting the problem as quickly
as possible is the best insurance.
!
WARNING
Keep your machine clean. Remove heavy trash deposits and
clippings from the machine. Keep all moving parts, hydraulic
system, engine cooling system and exhaust system clean of
trash and clippings. Accumulation of trash and/or clippings
can cause fires, hydraulic overheating and excessive belt
wear.
Clear away heavy build-up of grease, oil and dirt,
especially in the area of oil, fuel and engine combustion
air inlets and openings. Minute dust particles are
abrasive to close-tolerance engine and hydraulic
assemblies.
Some repairs require the assistance of a trained service
mechanic and should not be attempted by unskilled
personnel. Consult your Land Pride service center when
assistance is needed.
Torque Values
!
WARNING
Particular attention must be given to tightening the drive
wheel lug nuts and blade spindle bolts. Failure to correctly
torque these items may result in the loss of a wheel or blade,
which can cause serious damage or personal injury.
NOTE: Refer to "Torque Values Chart" and
“Additional Torque Values” on page 48 for correct
torque values.
It is recommended that the following be checked after the
first 2 hours of initial operation, and every 50 hours
following removal for repair or replacement:
• Wheel lug nuts
• Wheel motor nuts
• Blade bolts
• For engine torque values, see engine owner’s manual.
Control Lever Steering Adjustments
Refer to Figure 3-1:
The steering has been factory adjusted to eliminate
creeping when control levers are in neutral position.
However, should the mower begin to creep, adjustments
can be made as outlined on the following page.
Control Lever In Neutral Position
Figure 3-1
Control Lever
24911
Neutral and
Parking Slot
Section 3: Adjustments