Filter
Top Products
27
Section 4: Maintenance & Lubrication
2/27/07
Z44 & Z52 (S/N 472620 -526170) Zero Turning Radius Mowers Riding Mowers Accu-Z Razor
®
357-044M
Land Pride
Table of Contents
NOTES:
1. Initial engine oil and oil filter change is after the first 5 hours of operation. Thereafter, change engine oil and oil filter
every 50 hours of operation. Change every 25 hours when operating the engine under dusty or dirty conditions,
heavy load, high temperatures and hot weather periods. Refer to Engine Owner’s Manual.
2. Torque lug nuts initially and after first 2 hours of operation.
3. Refer to Engine Owner’s Manual.
4. Inspect pump and deck belt tensions every 6 months or 100 hours and replace if worn or cracking is noticed.
Otherwise, replace every 200 hours or 2 years whichever comes first.
5. Check fuel line hoses, fuel valve and grommet for any cracks or leaks.
6. Clean air cleaner more often under dusty conditions or when airborne debris is present. Replace air cleaner, if very
dirty.
7. Initial transaxle hydraulic oil and filter change is after the first 50 hours of operation. Thereafter, change transaxle
hydraulic oil and filter ever 200 hours of operation.
8. X/M = Service per hours indicated in column or monthly (whichever comes first).
Maintenance Schedule
Service at Intervals Indicated Every
25 Hours
Every
50 Hours
Every
100 Hours
Every
200 Hours
Refer to
Page
Clean mower, Deck & Engine Cooling System Daily (After engine has cooled.) 28
Verify Safety Start Interlock System Daily (Before each use) 13
Inspect Unit for loose hardware and damage Daily (Before each use) 28
Visually Inspect Tires Daily (Before each use) 29
Check Engine Oil Level Daily (Before each use or every 4 hours, whichever comes
first)
32
Clean Air Intake Screen Daily (Before each use or every 4 hours, whichever comes
first)
33
Check Fuel Level Daily (Before each use) 31
Blades - Sharp & Securely Fastened Daily (Before each use) 28 & 34
Discharge Chute -
Securely In Place & In Lowest Position
Daily (Before each use)
Service Air Cleaner (6) X 33
Grease Blade Spindle Bearings X 37
Change Engine Oil & Filter (1) X 32
Clean Cylinder And Head Fins X 33
Check Battery Connections X 9 & 29
Check Tire Pressure With A Gauge X 29
Clean Engine Exterior (3) X 33
Grease Deck Lift Pivot Points (8) X/M 38
Grease Front Azle Center Pivot (8) X/M 38
Grease Gauge Wheel Bearings X 38
Check Pump And Deck Belt Tension (4) X 33
Check Fuel and Hydraulic Lines (5) X 31
Tighten Lug Nuts On Wheels (2) X 28
Replace Air Cleaner Paper Element X 33
Change Fuel Filter X 32
Replace Spark Plugs X33
Change Transaxle Hydraulic oil & Filter (7) X 30