Jacuzzi J-280 Hot Tub User Manual


 
page 26



container filled with a solution of water and specially formulated filter
cleanser available from your authorized Jacuzzi dealer. The average life
expectancy of each filter is approximately two years with proper care and
water quality maintenance. Replacement cartridges may be purchased
from your authorized Jacuzzi dealer.
J
Trapped
Air
Bubbles
Submerge filter cartridge in
spa. Tilt threaded end upward to
remove trapped air bubbles,
then keep cartridge submerged to
prevent air entrapment during
installation (step H).
Install filter cartridge back onto wall
fitting by rotating the cartridge handle
clockwise. DO NOT OVERTIGHTEN!
Car
tridge
Rinse debris from filter cartridge pleats
using a garden hose and high-pressure
nozzle. Start at the top and work
downward to the handle. Repeat until all
pleats are clean.
H
I
J
Lift unthreaded filter cartridge from
skimmer well.
Install clean skimmer bag back onto the
filter cover clips as shown.
Install filter cover by sliding it down
into position over mating spa retainer
clips. Turn spa power back on after
skimmer cover is installed.
(Inside Spa View)
(Inside Spa View)(Filter Cover Back View)
J
Trapped
Air
Bubbles
Submerge filter cartridge in
spa. Tilt threaded end upward to
remove trapped air bubbles,
then keep cartridge submerged to
prevent air entrapment during
installation (step H).
Install filter cartridge back onto wall
fitting by rotating the cartridge handle
clockwise. DO NOT OVERTIGHTEN!
Car
tridge
Rinse debris from filter cartridge pleats
using a garden hose and high-pressure
nozzle. Start at the top and work
downward to the handle. Repeat until all
pleats are clean.
H
I
J
Lift unthreaded filter cartridge from
skimmer well.
Install clean skimmer bag back onto the
filter cover clips as shown.
Install filter cover by sliding it down
into position over mating spa retainer
clips. Turn spa power back on after
skimmer cover is installed.
(Inside Spa View)
(Inside Spa View)(Filter Cover Back View)