Filter
Top Products
page 13
3. Turn On Power
Turn on power to spa at the home’s circuit breaker to start boot up
-
to pages 31 for additional information.
4. Activate Jets Pumps
Turn on both jet pumps to ensure proper mixing when
adding start-up chemicals in step 5.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
6. Establish A Stable Sanitizer Reading
maintain a constant sanitizer reading within the levels recommended
the inside cover of this manual. If sanitizer levels cannot be stabi-
lized, perform the decontamination procedure steps 9-15 on page
Note: the “decontamination procedure” steps 9-15 should
also be used after the spa has been “Winterized” (section 11.7 page
28) or has been sitting without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature,
-
perature for 5 seconds. If you want the water to heat to a different
5 seconds. The set temperature increases or decreases by one
degree each time one of these buttons is pressed.
IMPORTANT: Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove
garden hose and replace filter cartridge. DO NOT
OVERTIGHTEN! FINGER TIGHT ONLY!
IMPORTANT: Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove
garden hose and replace filter cartridge. DO NOT
OVERTIGHTEN! FINGER TIGHT ONLY!
1
2
1
2