Filter
Top Products
766238 6/07 8-9
Carburetor Assembly - Mechanical Throttle
NOTES:
1. Torque 16-20 ft. lbs.
2. Apply Loctite® 242 to threads and torque to 12-15 ft. lbs.
3. Remove choke lever from right end of choke pivot shaft & reassemble
on left end of choke pivot shaft. With the choke butterfly in the horizontal
most position (fully choked) the choke lever should be positioned 1.00”
from the choke cable mount screw, as shown. Item 5 nut, item 4 lock
washer, item 3 flat washer & item 2 seal will have to be assembled on
right end of choke pivot shaft.
4. Item 17, adapter, can be installed two different ways, see Detail A.
Correct installation is shown in figure 2.
5. Used on tractors with serial numbers prior to 02034020.
INDEX
NO.
SERVICE
PART NO.
MFG. PART
NO.
QTY. DESCRIPTION
1 N/A 1 CARBURETOR (FACET)
2 710285 710285 2 CHOKE ROD SEAL
3 035691 035691 2 FW .210 X .50 X .046 ZN
4 056176 056176 4 LW #10 MEDIUM SPRING ZN
5 715581 715581 1 NT 8-36 HX ZN
6 714998 714998 2 MS 10-24 X .625 HX ZN
7 011841 011841 1 CONDUIT CLIP
8 038422 038422 1 CHOKE CABLE
9 434886 434886 1 CHOKE WIRE BRACKET
10 035626 035626 1 NT 10-24 HX ZN
11 044255 044255 1 NT 10-32 HX ZN
12 N/A 1 ELBOW 90°
13 708677 N/A 1 FILTER ASSEMBLY
14 708644 N/A 2 NT M8 X 1.250 HX ZN
15 N/A 1 GASKET (CARBURETOR TO ADAPTER)
16 N/A 1 GASKET (ADAPTER TO MANIFOLD)
17 714659 N/A 1 ADAPTER
18 066142 N/A 2 CS M6 X 1.00 X 2.00 SKHD
19 708610 N/A 2 STUD, M8 X 1.250 X 29.50
5