Filter
Top Products
766238 6/07 8-7
Choke Control Cable Assembly - 4500
NOTES:
1. Choke adjustment-position lever in middle of slot. Adjust cable so choke
plate is in maximum horizontal position that carburetor allows. Choke
plate must be vertical when lever is in off position.
2. Installation Instructions:
a. Use 3M™ Scotch-Grip™ 1300 adhesive or equivalent to install item
1, knob, onto item 9, choke lever.
b. Surface to be glued must be clean, dry & dust free. Wipe with solvent
if necessary.
c. Temperature of both surfaces should be 65° or more.
d. Allow to dry until adhesive is no longer tacky to the touch (minimum 5
minutes).
e. Use assembly tool 083535 to install knob on lever.
INDEX
NO.
SERVICE
PART NO.
MFG. PART
NO.
QTY. DESCRIPTION
1 083535 083535 1 KNOB
2 714998 714998 2 MS 10-24 X .625 HX ZN
3 035691 035691 2 FW .210 X .50 X .046 ZN
4 291765 291765 1 LEVER MOUNT BRACKET
5 056176 056176 2 LW #10 MEDIUM SPRING ZN
6 035626 035626 2 NT 10-24 HX ZN
7 715748 715748 1 NT .25-20 FLX LK
8 058081 058081 3 FW .250 X .750 X .10 NY
9 291542 291542 1 CHOKE LEVER
10 056077 056077 1 CS .25-20 X 1.00 HX G5 ZN
11 038422 038422 1 CHOKE CABLE ASSEMBLY
1
See Detail A
Detail A
2
REMOVE EXCESS ADHESIVE
FROM LEVER AFTER KNOB
IS INSTALLED
APPLY ADHESIVE
TO BOTH SIDES
.620 APPROX.
.750 INSTALLED
OF THIS AREA
1
6
5
3
4
7
8
9
8
10
2
11
1
9