58
Lubrication
Changing hydraulic oil
Hydraulic oil and filters should be changed by an
authorised Husqvarna workshop.
8. Hydraulic oil filter, change
Hydraulic oil filters should be changed by an
authorised Husqvarna workshop.
9. Cutting unit mounting
Lubricate ball joints and shafts with the oil can.
10. Lifting arm’s rear bearings
2 nipples, one on each side. Lubricate using a grease
gun until grease is forced out.
11. Driver’s Seat
Tilt the seat back.
Lubricate the lengthways adjustment mechanism with
the oilcan.
Lubricate the lengthways adjustment runners with
grease. Pull the seat back and forth and lubricate on
both sides.
IMPORTANT INFORMATION:
Used hydraulic oil is a health hazard and must not be
disposed of in the ground or in nature.
Replaced filters must be handed in to the workshop
or other allotted place for disposal.
Avoid skin contact; wash with soap and water in case
of spills.
Cutting unit mounting
Rear storage bearing
Driver’s Seat