Filter
Top Products
55
Lubrication
5. Lift cylinder
2 nipples, one at each end of the cylinder. Lubricate
using a grease gun until grease is forced out.
6. The power take-off shaft’s front support bearing
Lubricate using a grease gun until grease is forced out.
7. Engine Oil
Viscosity and quality
Use engine oil viscosity as illustrated, class API CH4
or ACEA E5 or higher.
The engine holds 2.5 litres of oil excluding the filter
(including filter 2.7 litres).
Checking the oil level
Check the oil level in the engine when the machine is standing
horizontally with the engine switched off.
Remove the dipstick and wipe it clean. Then insert the
dipstick again.
Take the dipstick out again and read the oil level.
The oil level should be between the markings on the
dipstick. If the level is approaching the “ADD” mark,
lower notch, top up the oil to the “FULL” mark, upper
notch on the dipstick.
Lift cylinder
The power take-off shaft’s front support bearing
-30 -20 -10 0 10 20 30 40 50 C
-22 -4 -14 32 50 68 86 104 122 F
0W
5W 20
10W 30
20
30
40
15W 40
20W 50
Viscosity chart
The engine dipstick