Filter
Top Products
40
Maintenance
4. Check that the pedal can be locked in the applied
position with normal pedal force.
5. Adjust as necessary using the wires' adjuster
screws (R and L).
Servicing the air filter
If the engine seems to lack power or does not run
smoothly this may be because the air filter is clogged.
When driving with a dirty air filter, the engine does not
receive enough air, which does not meet the
environmental demands, and the engine does not
operate at full efficiency.
It is important to replace the air filter regularly (see See
“Maintenance Schedule” on page 35 for the proper
service interval).
Emptying the particle trap
Compress so that the rubber tabs open and any
particles can drop out.
Cleaning the cyclone filter
Remove the cover held in position by two brace locks
and clean the inside of the cover. Wash with soap
water and blow dry using compressed air after
removing the cover.
Replacing the air filter
Remove the cover held by two brace locks. Pull the air
filter cartridge straight out and remove it.
Wipe the inside of the air filter housing dry. If
necessary, dampen the cloth with white spirit or fuel.
Water or compressed air must not be used.
Install a new air filter cartridge with the hole inwards
and press into position. It is important that the particle
trap is turned straight down when installing the cover.
IMPORTANT INFORMATION:
IMPORTANT INFORMATION:
Particle trap on air filter
Cyclone filter
It is important that the particle trap is turned
straight down when installing the cover.
Air filter cartridge
Do not use compressed air to clean the paper filter.
Do not wash the paper filter.
Do not oil the paper filter.