Filter
Top Products
21
Presentation
Other functions (option)
When the le
ver is moved laterally, the oil pressure is
operated to the 2nd hydraulic function, the terminals
are under the foot plate hatch.
22.
Switch for operation of cutting unit
The cutting unit can only be started when the driver is sitting in
the seat.
• Pull out the switch to engage cutting unit operation.
• Press in the switch to disengage cutting unit
operation.
If the safety circuit trips cutting unit operation, the
switch must be pressed in and pulled out again.
The safety circuit trips and the cutting unit stops:
When the cutting unit is raised to the uppermost
position
When the driver leaves the seat. There is a brief delay to
prevent stoppages should the driver bounce in the seat
When high gear is engaged.
When the starter is activated.
23. Switch for extra hydraulic function
(hydraulic kit option)
The switch is used, among others, when steering the
folding plough for individual control of the left or right-
hand plough-blades. Operate the plough blade using
the lever (21).
24. Push button for horn (traffic kit option)
25. Indicators (traffic kit option)
Press for the left-hand or right-hand indicator. Blinkers
are switched off automatically after approximately
30 seconds or manually by pressing in the same
direction. A new 30 second period is activated if you
press after the blinkers have been switched off.
Pressing in the opposite direction while flashing,
activates the blinkers for the opposite side for
30 seconds.
Switch for operation of cutting unit
Switch for extra 12 V outlet
Switch for horn
Switch for indicators