Filter
Top Products
64 – English
LUBRICATION
1. Open the engine cover.
2. Drain the engine oil as described under
”Changing the engine oil”.
3. Remove the oil filter. If necessary use a filter
spanner.
4. Coat the seal on the new filter with clean, fresh
engine oil.
5. Tighten the filter by hand until you feel it make
contact, then tighten a further 3/4 turn.
6. Run the engine until it is hot, then check that
there is no leakage from the oil filter seal.
7. Check the engine oil level and top up if
necessary. The oil filter holds 0.2 litres of oil.
13. Replacing the oil filter
IMPORTANT INFORMATION
Used engine or transmission oil is health-
impairing and must not be disposed of in
the ground or in nature.
Replaced filters must be handed in to the
workshop or other allotted place for
disposal.
Avoid skin contact; wash with soap and
water in case of spills.
WARNING!
The engine oil may be very hot if it
is drained immediately after
stopping the engine. Let the
engine cool down for a while first.
Pro 18
Pro 15
14. Hydraulic oil filter, change
1. Remove the oil filter. If necessary, use a filter
remover.
2. Wipe new, clean engine oil onto the seal for the
new filter.
3. Fit the filter by hand so it just touches + 3/4
turn.
4. Remove the transmission cover and fill the
transmission’s oil tank, about 0.3 l oil. See ”11.
Transmission oil level. Be observant when
running the engine as described below and fill
so that the tank is not emptied.
5. Run the engine warm, manipulate the servo
steering, and then check that there are no leaks
around the oil filter seal.
6. Check the oil level in the transmission, top up if
necessary. The oil filter holds 0.3 litres of oil.
7. Replace the transmission cover.