Filter
Top Products
English – 43
MAINTENANCE
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 kp/cm
2
/8,5
PSI) all round.
To improve driving the pressure on the rear tyres
can be reduced to 40 kPa (0.4 kp/cm
2
/5,6 PSI).
The maximum tyre pressure is 100 kPa (1,0 kp/cm
2
/
14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres
will result in the blades cutting the grass at
different heights.
Fuses
The main fuse is placed in a detachable holder
under the battery case’s cover, in front of the
battery.
Type: Flat pin, 15 A.
On Pro 18 there is also a power outlet fuse, this is
located under the ignition switch behind the side
plate on the control panel.
Type: Flat pin 7.5 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull
the fuse from the holder when replacing.
The fuse is there to protect the electrical system. If
it blows again shortly after replacement, it is due to
a short circuit, which must be fixed before the
machine can be put into operation again.