Filter
Top Products
62 – English
1. Open the engine cover.
2. Place a container under the drain plug on the
left side of the engine.
3. Take out the dipstick. Remove the drain plug
from the left side of the engine.
4. Let the oil drain out into the container.
5. Refit the drain plug and tighten it.
6. Replace the oil filter if necessary.
7. Fill with oil to the ”FULL” mark on the dipstick.
Use the grade of oil specified above.
8. Run the engine until hot and check that there is
no leakage from the drain plug.
WARNING!
Engine oil can be very hot if it is
drained off directly after the
engine is stopped. Therefore allow
the engine to cool down first.
IMPORTANT INFORMATION
Used engine oil is hazardous to health and
must by law not be poured out on the
ground or in the nature, but shall be
handed in to a workshop or special
environmental station. Avoid skin contact,
wash with soap and water in the event of
spillage.
Changing the engine oil
The engine oil must be changed after the first 8
hours of operation and every 100 hours thereafter.
When operating with a heavy load or at high
ambient temperatures, replace every 50 hours.
9. Gear lever
Remove the transmission cover by undoing the two
screws.
Lubricate the joints and bearings on the left side
using an oil can.
Push the rubber protector out of the way and
lubricate the hydrostatic wire using an oil can.
Press the pedal a few times and lubricate again.
Refit the rubber protector.
Refit the transmission cover.
LUBRICATION