Filter
Top Products
48
23. Make sure the cable moves freely. NEVER
kink the cable.
21. Check adjustment of the cable by tipping unit
forward confirming that when the control le-
ver is in the closed position the seedgate is
fully closed.
If the seedgate needs adjusting, loosen the
screw and nut holding the cable clamp. Move
the cable back or forward in the clamp until
the seedgate is fully closed when the control
lever is in the closed postion. DO NOT move
the seedgate with your hand, use the cable to
move the seedgate for a more accurate ad-
justment.
20. Attach the cable with a wire tie farther up the
handle.
24. Re-check the unit to see if it functions properly.
FIGURE 7
CABLE CLAMPSEED GATE
SEEDER ASSEMBLY
DT25
22. To check the seed dial adjustment , insert a 1/8"
drill bit into one of the holes in the seed gate, the
seed dial should read 3 1/2. If not, adjust the
cable by loosening the screw and nut holding the
cable clamp. Move the cable back or forward in
the clamp until the seed dial reads 3 1/2.