Filter
Top Products
45
BAGGER ASSEMBLY
Instructions for the catcher bag
Catcher bag
Insert the catcher bag into the underside of the
handle and open the safety door place bag on the
catcher chute.
See ”Assembly instructions\Assembly directions,
collector bag”.
Correct height setting
The thatch collected will be thrown into the catcher
by the force arising from the flail blades combing
through the grass. The blades may not strike the
soil. If the blades come in contact with the soil, they
will claw, which results in ineffective dethatching.
Collection conditions
One achieves best results if the lawn is short and
dry. Wet lawns make collection less effective. If the
grass is long, one may end up pulling and tearing
at the lawn. If the layer of thatch is thick, Husqvarna
recommends going over the lawn first in one
direction and then again in a perpendicular direction.
A thick layer of thatch may have formed over several
years, and the lawn may need combing 2-3 times
before it is removed completely. Do not attempt to
remedy a major problem by combing the lawn just
once.
Maintenance
Check prior to use that the catcher is properly
assembled and that the bag is not damaged. See
”Assembly instructions\Assembly directions,
collector bag”.
Clean the equipment after use.
WARNING!
Machines equipped with a catcher MUST
not be used with defective catcher bags or
without the catcher bag.
They pose a risk of thrown stones, eye in-
jury and inhalation of pollution.
DEPTH LEVER
DT02
DT03
FIGURE 13
FIGURE 14