Filter
Top Products
42
BAGGER ASSEMBLY
14. Install rubber flaps between flail blades on the
rake shaft. See Figure 3. If this shaft is installed,
you DO NOT have to remove the shaft from
the unit to install the the rubber flaps.
17. Install two extenders on the outside of the lower
handle assembly. Attach the lanyards with pins
to the extenders as shown in Figure 6.
RUBBER FLAP
FIGURE 3
12. Slide wheel on and apply two (2) retaining
rings. (Some units use a cotter pin instead.)
NOTE: The teeth on the retaining rings should point
away from the wheel.
13. Tighten wheel bearing hardware on both sides.
NOTE: If you have not installed the flail reel shaft,
do so now.
15. Remove belt guard. Remove cable by remov-
ing the pulley. See Figure 4. Attach new cable
and replace pulley. Save the old cable for use
when the bagger is not used.
CABLE
FIGURE 4
PULLEY
FIGURE 5
16. Attach the chute to the mainframe.
CHUTE
DT11
DT12