Filter
Top Products
20 - English
6.5 Replacing the chain catcher
A worn chain catcher must always be replaced with
a new one. Always use original spare parts.
1
Release the brake by moving the front hand guard
backward.
Loosen the bar nuts and remove the clutch cover,
chain and bar.
2
Remove the chain catcher and replace it with a
new one.
Make sure that the vibration element is tted cor-
rectly on the crankcase when a new chain catcher
is screwed in place. See gure 13.
Safety equipment
6.6 Dismantling the start/stop control
1
Remove the cylinder cover and air lter. Dismantle
the air lter holder. See the “Dismantling the carbu-
rettor” chapter.
2
Loosen screw B and dismantle the stop control A.
See gure 14. Unhook the rubber collar around the
control from the guide plugs.
Cleaning and inspection
Clean and check carefully all components. Parts
must be replaced if cracked or show signs of other
defects. Always use original spare parts.
Fig 13
Fig 14