Filter
Top Products
9-32 Command Reference
:DISPlay :ENABle PM6680B/81/85
8 < Boolean >
Display State
Turns On/Off the updating of the entire display section. This can be used for secu
-
rity reasons or to improve the GPIB speed, since the display does not need to be
updated. Turning off the display reduces the dead time between measurements
by about 7 ms.
When the display is turned off, the information about the measurement resolution
is lost. That is, the counter will always send a full 12 digit mantissa independent of
the measurement resolution.
Parameters:
Where <Boolean> = (1 / ON|0/OFF)
Returned format:
1|0 ¿
*RST condition: ON
See also: Chapter 6, ‘How to Measure Fast’.
Complies to standards: SCPI 1991.0, confirmed.