Dimension One Spas Dynamic Massage Sequencer Hot Tub User Manual


 
2002 Dimension One Spas Export Owner’s Manual
Hot Tub Features
Congratulations! You have purchased one of the finest portable hot tubs available. Take the time to read these
instructions carefully. If installed and maintained properly your hot tub will provide many years of enjoyable,
trouble-free operation. Read all of the instructions and view your owner’s manual video for further reference on
hot tub operation. If you have any questions, please
contact your local Authorized Dimension One Spas Dealer.
The following features are included on your hot tub:
Built to CE rating
Completely self-contained with load sharing capabilities
100% foam insulated
All hot tub shells are formed from UltraLife™ high impact thermoplastic or Granitex™ Acrylic
Designed for indoor or outdoor use
Top access, easy to clean filter systems using “Standby” mode
Water level referencing weir skimmer
Handcrafted cabinets
Proportional FastFlo™ Heater
A variety of interchangeable jets
Multiple jet systems with Selector Valve (except in the Aurora XLT, Aurora HP, Caliente HP, and Triad)
Exclusive, custom hand-set ceramic tile adds a distinctive touch
Polyethylene floor completely seals the hot tub, eliminating moisture or insect intrusion
Built-in, automatic freeze protection
Automatic high/low speed filtration cycles
Additional Features for the Chairman, Chairman II,
Diplomat, Californian, Nautilus, Aurora XLT, Aurora II,
Caliente HP, and Triad II
Scrolling Message Center with digital display, instructional, and maintenance messages
Ultra Pure™ Water Management System
NeckFlex™ Jet Pillow
Twin, long life, dual speed HydraMax® pumps
150 sq. ft. (13.94 m
2
) of filtration
Additional Features for the Arena, Aurora HP, Caliente, and
Triad
Programmable Digital control with digital display
CrystalZone™ Water Management System
Long life, dual speed HydraMax pump
75 sq. ft. (6.97 m
2
) of filtration
Jet System Selector Valve
All hot tubs (except the Aurora HP, Aurora XLT, Caliente HP, and Triad II) are equipped with spa-side Selector
Valves, see Figure 1. These valves can be used to divert jet power from one area within the hot tub to another.
The valves are adjustable and can be used to suit the bather’s taste. The valves may offer some resistance to
operation when the hot tub pump is on. This is a normal condition, and is caused by the high rate of water flow
and pressure that travels through the valves.
Figure 1. Selector Valve
5