Filter
Top Products
2002 Dimension One Spas Export Owner’s Manual
Ice
When “ICE CONDITION” and the water temperature are displayed on the Digital Display, the air temperature in
the equipment can has gone below a factory-preset level, and the system has activated “Smart Winter Mode.” It
will then automatically activate the pump(s) to circulate water. This is a normal hot tub function. No corrective
action is necessary. This feature protects the spa from freezing.
Cooling
When “COOLING” and the water temperature are displayed on the Digital Display, the water temperature has
reached 2° F (1.1° C) above the set temperature. The circulation pump and ozone generator will turn off to allow
the water to cool back to the set temperature. This is a normal hot tub function. No corrective action is
necessary.
Note
The circulation pump and ozone generator will be on while either jet pump is on and they will remain
on for 30 minutes after the pump(s) turn off regardless of the water temperature.
Note
The Dimension One Spas Scrolling Message Center will keep all programming for 40 years with no
power supply and the time of day for 30 days. This battery back up will not provide power to heat or
operate the hot tub.
Summer Mode
The “SUMMER MODE” feature temporarily disables the circulation pump “Cool Off” cycle. During hot weather
the spa can experience “Heat Creep”. Heat creep is caused when the spa, during normal maintenance operations,
cannot dissipate more heat than is generated. This may cause the spa temperature to exceed the set temperature
and cause a “Cool Off” cycle. In order to prevent the water from becoming cloudy due to the circulation pump
being turned off by the “Cool Off” cycle, the spa can be set to bypass the “Cool Off” cycle. This is accomplished
by setting the spa in the “SUMMER MODE”. To initiate a “SUMMER MODE”, use the Up and Down pads to set
the temperature to 59° F (15° C). The Digital Display will indicate “SUMMER MODE”. In this mode the pump will
run continuously until the water temperature reaches 107°F (41.67° C) and then turns off. It will remain off until
the water temperature reaches 102° F (38.39° C) at which point the pump turns on.
Standby Mode
The “STANDBY” mode allows the user to clean the filter without turning off power to the spa. This feature
disables all automatic and manual functions.
To enter the “STANDBY” mode press and hold the Dimension One Spa”s ICON logo for 5 seconds. To exit the
mode, press and hold the logo for 5 seconds. If you do not exit the mode manually, the spa will automatically
return to normal functionality after 24 hours.
Note
The “Smart Winter” mode is not affected by the use of the “Standby”: mode.
15