Filter
Top Products
2002 Dimension One Spas Export Owner’s Manual
Using the Scrolling Message Center
Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through customizing
your hot tub to your exact needs. To initiate the programming sequence at any time, push and hold the Program
pad for 3 seconds. If, within 10 seconds, you do not proceed with the hot tub programming, the hot tub will
automatically exit the programming sequence and revert to the pre-set factory default settings. To exit the
programming sequence at any time, push the Enter pad or do not press a pad for 10 seconds. Any programming
changes made up to that point are saved.
Setting the Time
After holding the PROGRAM pad, the top line of the Digital Display will read “SET TIME OF DAY” and the
bottom line will read “PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO SELECT NEXT FUNCTION
- PUSH ENTER TO EXIT ”. Push the UP or DOWN pads to engage the time setting mode. The time screen will
appear with “hours” (_ _.00) flashing on and off. Push the UP or DOWN pad to increase or decrease the number
until the desired hour appears. When the desired number is displayed, push the LIGHT pad to accept the selection
and change the flashing number to the “ten minute” place (12:_0). Adjust the number with the UP or DOWN pad
in the same manner as the hour number. When the desired indicator is displayed, push the LIGHT pad to accept
the selection and change the flashing number to the “minute” place (12:1_). Adjust this number with the UP or
DOWN pad in the same manner as the hour number. When the desired number is displayed, push the LIGHT pad
to accept the selection and change the flashing number to a flashing AM or PM indicator. Adjust the indicator with
the UP or DOWN pads. After reaching the correct time, push the PROGRAM pad to set the time and exit the
time setting mode. You will then be prompted to set the filter start time.
Filter Cycle Start Time
After setting the time-of-day, the top line of the Digital Display will read “SET FILTER CYCLE TIME”. Push the UP
or DOWN pads in the same manner as setting the clock to select the time you want your filter cycle to start.
When your desired filter cycle start time is set in the display, push the PROGRAM pad to continue. The pre-set
factory default is 12:00 p.m. to 1:00 p.m. repeating every 12 hours unless the number of filter cycles per day has
been changed.
Note
Keep in mind that you will later be prompted to set the filter cycle duration and the number of
filter cycles. Be sure to keep this in mind when programming your filter cycle start time.
During a filter cycle, the bottom left of the Digital Display will read “SPA FILTERING”. During the filter cycle, JETS
1 will activate, the first 5 minutes at high speed and the remainder of the filter cycle time at low speed. JETS 2 will
also activate for 1 minute on high speed and then turn off.
Filter Cycle Duration
After setting the filter cycle start time, the top line of the Digital Display will read “SET CYCLE DURATION”.
Push the UP or DOWN pads to toggle between 60, 90, 120, 150 and 180 minutes. The first 5 minutes of the filter
cycle will be at high speed and the remaining time at low speed. When your desired filter cycle length appears in
the Digital Display, push the PROGRAM pad to select it. The pre-set factory default is 60 minutes.
Number of Filter Cycles
After setting the length of the filter cycle, you will be prompted to set the number of filter cycles. The top line of
the Digital Display will read “SET # OF CYCLES”. Push the UP or DOWN pad to toggle from 1 to 2 to 3 to 4
cycles per day. When your desired number of cycles appears on the Digital Display, push the PROGRAM pad to
select it. The pre-set factory default is 2 cycles per day.
Caution
Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot
climates.
16