Filter
Top Products
2002 Dimension One Spas Export Owner’s Manual
Warning
Do not attempt to remove the light housing cover without lowering the water level below the light
housing cover.
Note
Do not attempt to remove the light housing cover without the special tool. If you are not able to
locate it, contact the Dimension One Spas’ Service Department to have one sent.
Note
Be sure the O-ring is not damaged and is properly in place when replacing the lens. Contact
Dimension One Spas if a replacement O-ring is needed.
Feature
A Dynamic L.E.D. Light is available as an optional accessory for many models. This light is
preprogrammed with 13 different light shows. This light is also replaced in the same manner as
described in the previous paragraph. Contact your dealer or visit our Virtual Showroom at
http://d1spas.com
to see if it is available for your model.
Surface Care – Ultralife and Granitex
Your equipment has a very high quality finish. Stains and dirt will generally not adhere to the surface. We
recommend cleaning the entire shell surface with Dimension One Spas’ Water Line Cleaner. You may also use
Dimension One Spas’ ph/Alkalinity Increaser or mild cleaners like Soft Scrub. Be sure to thoroughly rinse the
shell. After cleaning, you will want to restore your hot tub shell’s original luster by using Dimension One Spas’
Poli-Gloss.
Caution
Do not use “409” type cleaners or other caustic solutions as they may damage the hot tub shell
surface and void the warranty. If you are using baking soda to clean your hot tub shell, be careful
not to get it on the skirt. It may bleach the wood.
Caution
Do not use citrus-based cleaners on the shell surface.
Granitex
/Quarite Plus
If your spa is equipped with this material you must keep the spa covered when it is empty. When the spa is empty
and the cover is not in place, and the spa is exposed to direct sunlight, it is vulnerable to ultraviolet light or solar
damage. Temperatures generated by sunlight can become concentrated in the shell surface causing the shell
material to delaminate from the urethane backing.
Dimension One “ EnviroTect” Skirts and Vinyl Covers
The Dimension One EnviroTect skirts are unaffected by most corrosive substances, and will not absorb
moisture. To maintain the original finish, clean with soap and water. No sealing or painting is required. To
maintain a “nearly original” appearance we recommend applying 303 Protectant at least once a month on the
Dimension One EnviroTect skirts and on the vinyl covers if they are exposed to direct sunlight. 303
Protectant is rated at 40 SPF (Sun Protection Factor).
25