Filter
Top Products
2002 Dimension One Spas Export Owner’s Manual
Operation
Operation is divided into two sections: Programming the Digital Control for the Arena, Aurora HP, Caliente, and
Triad (following section) and Programming the Scrolling Message Center for the Aurora II, Aurora XLT, Caliente
HP, Californian, Chairman, Chairman II, Diplomat, Nautlilus, and Triad II (proceed to the Programming the
Scrolling Message Center section).
Programmable Digital Control for the Arena, Aurora HP,
Caliente, and Triad
Advanced microprocessor technology has been utilized to produce the Programmable Digital Control. Easy to use
and understand, Dimension One Spas has put every hot tub function within fingertip control. Temperature setting,
jet power control, and the hot tub light are all spa-side accessible. That means you don’t have to get out of the hot
tub to enjoy complete control of all hot tub functions. Safety is assured through design concepts and materials that
meet or exceed CE rating.
Digital Control, Figure 3, lets you relax and enjoy everything your hot tub has to offer.
Note
Gain a thorough knowledge of the following information before starting up your spa
Figure 3. Digital Control
Top Side Control
Control Function
1
1. Digital Display
The digital display indicates (depending on program mode) temperature in
degrees F or C, time, filter cycle start time, filter cycle duration time, and
number of filter cycles. For more information see “Digital Display Messages”.
2
2. JETS (Low/High Control) Pad
When the JETS pad is pushed, the hot tub jet pump is energized and the JETS
Status Light (1) will illuminate. Each time the pad is pushed it will activate a 30
minute automatic shut-off cycle. This auto shut-off cycle is a safety device and
also allows for convenient filtration immediately after using the hot tub. The
first time a pad is pushed the pump is turned on. When the same pad is pushed
again, the pump will turn off.
NOTE: Pushing the JETS pad will disable any concurrent filter cycle.
7