Filter
Top Products
2002 Dimension One Spas Export Owner’s Manual
Control Function
2
2. JETS Pad
Operates the jet pump associated with the Massage Sequencer. Status Light
illuminates when pump is on.
3
3. SPEED Pad
The SPEED pad is used to change the time between each step in all sequences.
The default time is factory programmed for 5 second intervals. The first push of
the SPEED pad will change the step interval time to 15 seconds, the second push
will change the intervals to 30 seconds and the third push will reset the speed to
5 second intervals. The LED indicator below the SPEED pad will blink at the speed
at which the system is operating. During a Pause condition the Speed LED
indicator will be OFF
4
4.BEGIN/PAUSE Pad
The BEGIN/PAUSE pad is used to interrupt the massage sequence and to start a
particular sequence. For example, if the user likes the jet massage at a particular
moment during the sequence, and wants to keep it for an extended period of
time, the user may press the Begin/Pause pad and the system will remain in the
specific configuration until the pad is pushed again. The Begin/Pause status light
will be on when the system is in the Pause mode. During this mode, the matrix of
LED's will preview the sequence and the user may also push the SEQUENCE pad
to preview another sequence
5
5.SEQUENCE Pad
The SEQUENCE pad is used to toggle between selected massage sequences.
When a sequence has been selected, the corresponding LED indicator 1-6 will
light. The default mode (all jets in the lounge operating) will not be indicated by a
light
6
6.Massage Zone Indicator Lights (Human Figure)
When a sequence is chosen, one or more LED in the figure will illuminate
showing the active zones in that sequence.
7
7.SEQUENCE Indicator Lights (1 through 6)
When a sequence has been chosen the corresponding light will illuminate. When
the default mode (all jets in the lounge operating) is selected, no light will be
illuminated.
19