Filter
Top Products
2002 Dimension One Spas Export Owner’s Manual
Clean Filters
On alternating months, the top line of your Digital Display will read, “DIRTY FILTER” and the message “REMOVE
FILTERS & CLEAN IN SOLUTION... PUSH AND HOLD ICON PAD MORE THAN 3 SECONDS TO RESET THIS
MESSAGE” will scroll from right to left on the bottom line of the display. To reset this message, push and hold the
Dimension One Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
Change Water
Every four months the top line of your Digital Display will read “CHANGE WATER” and the message “TURN
POWER OFF, DRAIN & REFILL SPA...PUSH AND HOLD ICON PAD MORE THAN 3 SECONDS TO RESET
THIS MESSAGE” will scroll from right to left on the bottom line of the display. To reset this message, push and
hold the Dimension One Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
Change Vision Cartridge
When “CHANGE VISION CARTRIDGE” is displayed on the LCD, the system is telling you that it is time to
replace it. To reset this message, push and hold the Dimension One Spas ICON (logo) pad located at the right
hand side of the control for 3 seconds.
Note
If you purchased a Vision cartridge subsequent to the initial start up of your hot tub, please follow
the programming instructions for VISION as outlined in the next section (titled, “Vision
Cartridge”) to set the six-month time frame.
Spa Check Up
When “SPA CHECK UP” is displayed on the Digital Display, we recommend that you have your hot tub inspected
by your dealer as a preventative maintenance measure. To reset this message, push and hold the Dimension One
Spas ICON (logo) pad located at the right hand side of the control for 3 seconds.
Note
The system can dismiss and reset the maintenance messages by pushing and holding the
Dimension One Spas ICON (logo), on the right end of the control, for 3 seconds. If you press the
Dimension One Spas ICON (logo) for 5 seconds when there is no maintenance message, it will
put the spa in the “Standby” mode.
Overheat
When “OVERHEAT” is displayed on the control system Digital Display, the hot tub is in a high temperature
condition. If such a condition exists, check water temperature and if it is above 104° F (40° C), DO NOT
ENTER THE WATER. If this happens, remove the hot tub cover and allow the water to cool below 110° F
(43.3° C). Reset the power to the spa by resetting the GFCI breaker. If the problem recurs, turn off all power to
the hot tub and contact your local Authorized Dimension One Spas Dealer, or authorized service center
.
Flashing Display and/or “Check Water Level”
If you see 3 flashing LEDs (on Digital Display) and/or the message, “CHECK WATER LEVEL -CLEAN FILTER-IF
PROBLEM CONTINUES, TURN OFF POWER AND RESTART THE SYSTEM-IF PROBLEM CONTINUES, CALL
FOR SERVICE” on the Digital Display, follow the instructions as stated. Check the water temperature and if it is
above 104° F (40° C), DO NOT ENTER THE WATER.
Flashing Temperature on the Display
If you see a flashing temperature of 34° F (1.11° C) or 134° F (56.6° C), DO NOT ENTER THE WATER. The
system has detected a problem. Call your dealer for service.
14