Filter
Top Products
Dimension One Spas - Bay Collection - Owner’s Manual
31
Water System
Symptom Problem Corrective Action
Pulsating jets
Water level too low Fill with water to approximately 6 inches below the top of the spa.
1. Jets are turned off 1. Turn jets on by turning jet face clockwise
2. Diverter Valve turned 2. Turn the Diverter Valve clockwise or counter clockwise
3. Dirty Filter 3. Clean Filter, including inner filter screen
4. Air lock 4. Loosen pump union to allow air to bleed
No Jet Action, or
action is poor
5. Gate valve closed 5. Open gate valve
1. Check water level
2. Clean filter, including inner filter screen
3. If problem continues:
a. Turn off power
b. Restart the spa
The “Check
Water Level…..”
message and /or 3
flashing lights
appear on the
display.
Possible sensor errors
4. If problem persists:
a. Call your dealer for service
Fountain doesn’t
drain
The bottom of the fountain
has water that will not
drain out.
The water level in the spa is too high. Remove enough water to return the water
level to about 6 inches below the top of the spa, at a level where the fountain water
can drain out.