Filter
Top Products
Dimension One Spas - Bay Collection - Owner’s Manual
26
Cleaning the Filter Screens
The Filter Screen is a black plastic perforated cylinder located at
the bottom of the canister that holds the filter. It normally
requires no maintenance. However, if the spa frequently says to
clean the filter, or if the spa is reporting “low water flow,” clean
the screen in addition to the filter.
First, remove the filter(s) as described in the Filter Cleaning
section above.
Then locate the black
plastic Filter Screen at the base of the filter canister (see photo at left).
Remove the filter screen by inserting the tip of a flat-blade screwdriver into the slot as shown,
and gently apply outward pressure until the catch releases. Then lift the black screen to remove it
from the filter canister. Outside the spa, rinse the screen with water using pressure from inside
the screen.
Cleaning the UltraPure Inner Filter Screen
The UltraPure filter (if the spa is equipped with it) contains a
metal Inner Filter Screen inside the black plastic Filter
Screen. (This inner screen is not present in the skimmer
filter).
To clean the Inner Filter Screen, first remove the entire plastic
Filter Screen as described above.
Then remove the Inner Filter Screen and clean both screens with
water, using pressure from the inside of each screen.
Replace the Inner Filter Screen into the plastic Filter Screen by
lining up the grooves (shown by the arrow in the photo) and
pressing it snugly into position.
Then press the Filter Screen (with the Inner Filter Screen
inside) back onto the base of the spa filter canister.
Finally, replace the filter into its canister and replace the lid.
Then turn the power back on or exit the “Standby” Mode, if it was used, as described above.
To prevent debris from getting into the pump, be sure to
remove any floating debris BEFORE removing the Filter
Screen.