Filter
Top Products
7
1. Assemble the handle support tube (5) to the LH
blade hitch assembly using the hex cap screws
(13) and hex lock nuts (12). See Figure 4.
Figure 4
2. Slide the blade pivot handle (6) through the eyelet
of the handle support tube (5). Attach to the blade
angle arm of the pivot plate with the shoulder bolt
(16) and flanged lock nut (15). See Figure 5.
Figure 5
CAUTION
Route the cable as shown in Figure 6. Make
certain the cable has a smooth, even bend and
will not be kinked or pinched.
3. Route the pivot release cable along the upper
surface of the blade pivot handle to the top of the
handle (See Figure 6).
Figure 6
4. Slide the flat weld nut (17) into the release cable
trigger housing. See Figure 7.
Figure 7
BLADE HITCH
HEX CAP
SCREW
HEX FLANGE
LOCK NUT
HANDLE
SUPPORT
TUBE
ASSEMBLY
BLADE PIVOT
HANDLE
SHOULDER
BOLT
LOCK
NUT
ANGLE
ARM
HANDLE
SUPPORT
TUBE
EYELET
PIVOT
RELEASE
CABLE
SMOOTH
BEND
BLADE
PIVOT
HANDLE
TRIGGER
HOUSING
FLAT
WELD
NUT