Filter
Top Products
BELT INSTALLATION -
4. Install new belt in reverse order of
removal.
5. Make sure belt is in all pulley grooves
and inside all belt guides.
6. Install mower in reverse order of
removal instructions.
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxle.
If tractorrequires more thansix (6) feet
stoppingdistance at high speed in highest
gear, then brake must be adjusted.
1. Depress clutch/brake pedal and
engage parking brake.
2. Measure distance between brake
operating arm and nut "A"on brake rod.
3. If distenceis otherthan 1-9/16',loosen
jam nut and rum nut=A" untildistance
becomes 1-9/16". Retighten jam nut
against nut"A".
4. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance isstill
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact a Sears or other qualified
service center.
With Perking Brake "Engaged"
ut _A"
_nt is ne_ssa_ coned your nearest
_uthodzed service center/department
ro REPLACE MOTION DRIVE BELT
°ark the tractor on level surface. Engage
3arking brake. For assistance, there is a
_elt installation guide decal on bottom
;ida of left footrest.
L Remove mower (See "TO REMOVE
MOWER" in this section of this
manual.)
2. Remove belt from stationary idler and
clutching idler.
3. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
4. Pull belt toward front of tractor and
remove downward from around
engine pulley.
5. Install new belt by reversing above
procedure.
Engine
Pulley
Clutching Idler-
StationaPj Idler_
Transmission
Input Pulley.,
TRANSAXLE MOTION CONTROL
LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset
at the factory and adjustment should not
be necessary.
t. Loosen adjustment bolt in front of the
right rear wheel, and lightly tighten.
2. Start engine and move motion control
lever untiltractor does not move
forward or backward.
3. Hold motion control lever in that
position and turn engine off.
4. While holding motion control lever in
place, loosen the adjustment bolt.
5. Move motion control lever to the
neutral (N) (lock gate) position,
6. Tighten adjustment bolt securely.
NOTE: If additional clearance is needed
to get to adjustment bolt, move mower
deck height to the lowest position.
After above adjustment is made, if the
tractor still creeps forward or backward
while motion control lever is in neutral
position, follow these steps:
1. Loosen the adjustment bolt.
25