Filter
Top Products
HOW TO SET UP YOUR TRACTOR
CONNECT BATTERY
ACAUTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. Before connecting battery, re-
move metal bracelets, wristwatch bands,
rings, etc. Positive terminal must be con-
nected first to prevent sparking from acci-
clental grounding.
• Remove cardboard packing from seat
pan and lift seat pan to raised position.
• Open battery box door and remove pro-
tective plastic.
• Remove terminal protective caps and
discard.
• If this battery is put into service after
month and year indicated on label (label
located between terminals) charge bat-
tery for minimum ofone hour at 6-10
amps.
• First connect RED battery cable to posi-
tive (+) terminal with hex bolt, flat wash-
er, lock washer and hex nut as shown.
Tighten securely.
• Connect BLACK grounding cable to
negative (-) terminal with remaining hex
bolt, flat washer, lock washer and hex
nut. Tighten securely.
Discard Terminal
.i_ Proctec_ve Caps
Lock Washer Flat
Washer
. Hex
Hex
Positive =Negative
(Red) Cable (Black)Cable
• Close batteryboxdoor.Open battery
box doorfor:.
• inspection forsecureconnections
(to tightenhardware).
• Inspectionfor corrosion.
• Testingbattery.
• Jumping(ifrequired).
• Periodiccharging.
Seat Pan
Battery
Box Door
INSTALL SEAT
Adjust seat before tightening adjustment
knob.
• Remove cardboard packing on seat pan.
• Place seat on seat pan and assemble
shoulder bolt. Tighten shoulder bolt
securely.
• Assemble adjustment knob and flat
washer loosely. Do not tighten.
• Lower seat intooperating position and
sit on seat.
• Slide seat until a comfortable position is
reached which allows you to press
clutch/brake pedal all the way down.
• Get off seat without moving its adjusted
position.
• Raise seat and tighten adjustment knob
securely.
Seat
Seat Pan
Shoulder
Bolt _._..
Adjustment Knob
Flat Washer
9