Filter
Top Products
CAUTJSN!Alcohoi-btended fuels(caiiedgasohoi, ethanol or
methanoi) can attract moisture, which ieadsto separation and
formation of acids during storage.Acidic gascan damagethe
fuei system of an enginewhile in storage.
Toavoid engine problems, the fuel system should betreated
with a fuei preserveror emptied before storage of 30 days or
longer, if adding a fuel preserver,fiii the fuel tank with fresh
fuei. if only partialiyfilied, air in the tank wiii promote fue!
deterioration during storage, if fuei preserver is not used,
drain the fueItank, start the engine and iet it run untii the fuel
lines and carburetor are empty. Usefresh fueI next season.
See Storagefor additional information.
NEVERuseengine or carburetor cleanerproducts inthe fuel
tank as permanent damagemayoccur.
NighAltitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane/ 85 AKI (89 RON)gasoline is acceptable.To
remain emissions compliant, high aititude adjustment is
required. Operationwithout this adjustment wiii cause
decreasedperformance, increasedfuet consumption, and
increasedemissions. Seea qualified Searsdealer for high
altitude adjustment information. Operationof the engine at
altitudes below 2,500 feet (762 meters) with the high altitude
kit is not recommended.
CennectHeseand Water Supply te Pump
[
IDO NOT the without the connected
run
pump
water
supply
and turned on,
Damageto equiprnentresultingfrom failureto followthis
instructionwillvoidwarranty
NOTE:Removeand discardthe shipping caps from the
pump's high pressure outtet and waterinlet beforeattaching
hoses.
1. Uncoil higil pressure hose and attach one endof hoseto
baseof spray gun. Tigilten by hand.
WARNING
Thehigh pressurestream of water that this
1_ equipment produces cancut through skin and its
underiyingtissues, ieadingto serious injury and
_ossibieamputation.
, NEVERconnecthighpressurehoseto nozzleextension.
• Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized.
• Alwaysbecertainspraygun,nozzlesandaccessoriesare
correctlyattached.
2. Attach other end of high pressure hoseto high pressure
outiet on pump. Tighten by hand.