Craftsman 580.75213 Pressure Washer User Manual


 
.
Insert spray gun holder wireform (A) through holejust
abovecleaningtank on left side of handle (viewing from
front of unit). Hold wimform in placeand attach a piastic
knob (B) from inside of unit. Tighten by hand.
l
Attach Detergent Siphon Hose to Pump
Thepressure washer is equipped with two detergent
siphoning hoses.One is attachedto the cleaningtank and
one is loosefor siphoning pressure washer safedetergents
from a bottle or container.
Attach one of the detergent siphon hoses (A) to the barbed
hose fitting (B) on the pump.
IMPORTANT:Only onedetergent siphoning hosecan be used
at a time. When cteaningtank is not used, makesure
detergent shut=offvalve oll cleaningtank is in the "Off"
position.
Add Engine Oil
1. Placepressure washer on a fiat, bvei surface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
NOTE:See Oi/Recommendations in Ma,_otenancesection.
Verify provided oii bottle is the correct viscosity for current
ambient temperature.
3. Using oii funne! (optional), sIowiy pour contents of
provided oil bottle into oil fill opening.
improper treatment of pressurewasher can damageit and
shorten its iife.
DONOTattempttocrankor stat theenginebeforeit hasbeen
properlyservicedwiththerecommendedoil.Thismayresultin
anenginefailure.
4. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel must meet these requirements:
. Clean,fresh, unleadedgasoline.
o A minimum of 87 octane/87AKi (91 RON).High altitude
use, seeHigh A/titude.
. Gasoiinewith up to 10% ethanoi (gas@@ or up to 15%
MTBE(methyl tertiary butyl ether) is acceptable.
Avoid pressure washer damage.
Failureto follow Operator's Manualfor fuei
recommendations voids warranty.
DONOTuseunapprovedgasolinesuchasE85.
DONOTmixoil ingasoline.
DONOTmodifyengineto runon alternatefuels.
To protect the fuel system from gum formation, mix in a fuel
stabiiizer when adding fueI. See Storage.Ali fuei is notthe
same. if you experiencestarting or performance probiems
after using fuel, switch to a different fuel provider or change
brands. This engineis certified to operateon gasoline.The
emission control system for this engine is EM (Engine
Modifbations).
WARNING
Fueland its vapors are extremely flammable and
explosive.
Fireor explosion can causesevere burns or
death.
WNENADDINOFNEL
o TurnpressurewasherOFFandletit coolatleast2 minutes
beforeremovingfuelcap.Loosencapslowlyto relievepressure
in tank.
o Fillfuel tankoutdoors.
DONOToverfilltank.Allowspaceforfue!expansion.
o Iffuelspills waituntilit evaporatesbeforestartingengine.
Keepfuelawayfrornsparks,openflames,pilotlights,heat,and
otherignitionsources.
DONOTlighta cigaretteorsmoke.
Cleanareaaround fuet fill cap, removecap.
Siowiy add regular unleadedfuel (A)to fuet tank (B). Be
carefui not to overfiii. Aliow about 1.5" (4 cm) (C) oftank
space for fuel expansion.
®
1.
2.
3. Install fuel cap and wait for anyspilled fuel to evaporate.