Filter
Top Products
Atria
™
7
Structural Support
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where
you wish to place your Casablanca fan, an approved
ceiling fixture outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either the circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
it is marked “Approved for Ceiling Fan Mounting.” If it is
not, a new box must be installed. For new construction,
use an approved ceiling fixture outlet box with the rating
“50 lbs. or less”. Ensure that the outlet box is mounted to
a joist or stud beam. If not, a 2x4 stud must be installed.
WARNING! Ñ To reduce the risk of fire,
electrical shock, or personal injury, mount
to outlet box marked “Acceptable Fan
Support of 22.7 kg (50 lbs.) or less” using
the mounting hardware provided with the
outlet box.
When to Use a Lag Screw
A lag screw is required under two conditions: the fan
weighs 36 lbs. or more, or the existing ceiling fixture
outlet box needs to be modified for a ceiling fan
application (for example, you are replacing an existing
light fixture with a fan). We recommend that the ceiling
box be of sufficient capacity to support the weight
of the fan and light fixture under any conditions.
NOTE: The Atria weighs 42 lbs., so use of a
lag screw is required.
Mounting Guidelines
Before mounting your Casablanca fan, read the
following helpful recommendations. Location,
fan size, and structural support are important
factors to consider before installation.
Location
Ceiling fans have practical uses in almost every
room in your home. We suggest you follow
these mounting recommendations as you decide
where to install your Casablanca fan.
For safety reasons, the fan blades must •
be a minimum of 7' above the floor.
Do not locate the fan in a doorway •
or above a swinging door.
In bedrooms, fans work best when •
mounted above the foot of the bed.
Over pool tables, be sure to provide plenty of •
clearance to avoid damage from pool cues.
In kitchens be sure to allow for open •
cupboard doors to clear the fan blades.
Do not install a fan close to or over a pool or spa. •
High humidity combined with corrosive gases
will destroy the finish and warp the blades.
Fan Size
Variable fan speed capability permits the use of
a full-size fan even in smaller rooms. For very
large rooms, two fans may be needed.