Filter
Top Products
Atria
™
12
3 Slide adapter cover onto downrod, then route the
fan wires through the downrod and ball assembly.
4 Insert the downrod into the motor coupling
and turn clockwise. When the downrod is securely in
place, re-tighten the set screw with the Allen wrench
until it will not turn any further. Test the stability of
the downrod assembly by attempting to unscrew the
downrod from the motor coupling. If the downrod turns
in either direction, the set screw should be tightened.
CAUTION: Ñ The downrod has a tapered
thread designed to lock completely when
correctly installed. Failure to fully lock in
the downrod before securely tightening
the set screw may cause the fan to
separate from the downrod and fall
during normal operation.
5 Lower the adapter cover over the motor coupling.
6 Screw in the eight lightbulbs.
STEP 6
Adapter cover
STEPS 3-4
Set screw
Downrod and ball
assembly
Allen wrench
Motor wires
Tapered thread
Motor coupling
Adapter cover
STEP 5