Filter
Top Products
Section 4. TLX106 Sensor Arm Installation
4-3
4.5 RH and Temperature Radiation Shield
Mount the radiation shield to the sensor arm as shown in Figure 4.4-1.
Remove yellow cap. Place the RH and temperature assembly inside the shield
shaft. Attach the shield to the sensor arm with the two screws.
4.6 Pyranometer
Level the pyranometer as indicated in Figure 4.6-1. Adjust the three leveling
screws until the bubble level indicates plumb. Remove the red cap from the
pyranometer.
FIGURE 4.6-1. Pyranometer Leveling
4.7 Sensor Verification and Clock Set
Check the measurements of all sensors after the datalogger is programmed.
Display measurements using the *6 Mode with the CR10KD.
Leveling
Screws